Fisher & Paykel Eson 2 Nasal CPAP Mask

Eson 2 Nasal Mask

The Eson 2 is designed to meet the needs of patients and sleep therapy professionals with every step through the CPAP therapy. The Eson 2 is built for performance and comfort whilst focusing on ease of use. With only three simple parts, the nasal CPAP mask is easy to clean and easy to assemble. The Eson 2 is quiet and has minimal draft allow for an uninterrupted sleep.

Features

• VisiBlue™ highlights key mask components which assist patients with general use and placement when dissembling and reassembling the mask.
• Washable diffuser which reduces noise and draft.
• RollFit™ Seal delivers a more precise fit and prevents further pressure and discomfort on the bridge of the nose.
• Easy Frame slimmer frame provides a clear line of sight.  Whilst fitting all three cushion sizes and has Easy-Clip frame attachments that connect to the nasal mask.
• Intuitive Headgear redesigned for improved usabiltiy and fitting.  Traditional clip fitting method. Improved clip ergonomics.  Improved fasteners.  New VisiBlue top strap for easier patient orientation.  New stretch over option.

Eson 2 Mask Sizes

It comes in size S (small cushion & small headgear), M (medium cushion & M/L headgear) and L (large cushion & M/L headgear).

It also comes in “FitPack” packaging, which has three cushions in different sizes: small, medium, large; and a M/L headgear.

Mask Fitting

• Stretch over – for quick fit, mask stretches directly over your head
• Hold the bottom grey straps with the mask facing downwards
• Guide the headgear over your head so that the silicone seal is resting on your forehead
• Place your hands on the straps either side of the mask
• Pull out and downwards
• Ensure the silicone seal rests over your nose, and the blue top strap is sitting on your forehead
• Gently take the headgear strap of the mask headgear.  Starting with the blue top strap followed by the bottom straps.

Fitting tips

• If you experience seal leaks lift the silicone seal off your face and reposition it again
• Ensure the headgear straps are not fastened too tightly
• The forehead strap should rest horizontally on the forehead, just above the ears
• A good fit is snug around the head and not too tight

Cleaning

• Remove your mask by placing your hands on either side of the mask frame and pulling the silicone seal off your nose, and lifting the mask back over your head.
• Unhook headgear clips from mask frame
• Remove silicone seal, diffuser and the swivel from mask frame
• Wash these parts in warm soapy water after every use
• After washing, rinse all parts with fresh water
• DO NOT CLEAN ANY ITEMS in your DISHWASHER
• Once a week you should also wash your headgear and diffuser in warm soapy water
• Do not soak all parts more than 10 minutes
• Air dry all parts out of direct sunlight

Assemble your mask

• Push the silicone seal onto mask frame, using the blue ring for orientation
• Push the swivel onto the end of the elbow and place the diffuser onto the elbow, and place the diffuser onto the elbow.
• Thread the forehead straps of the headgear through the slots of the mask frame
• Hook the headgear clips back onto the mask frame

Mask Material List:

• Frame and Elbow: Polycarbonate
• Swivel and Seal: Polycarbonate Silicone
• Headgear: Lycra / Polyurethane Foam Laminate
• Headgear Clips: Acetal
• Diffuser: Polycarbonate / Polyester Fiber